Asked by: Sfia Masmano
asked in category: General Last Updated: 15th March, 2020

How do I make a hole punch without a hole puncher?

If it is for a three ring binder: put paper in the rings and either punch through it or if you don't like that, make an imprint on the paper and use a toothpick to poke holes. If it's not for a binder, just use a toothpick. I like to poke three holes in a small triangle and then poke out the middle.

Click to see full answer.


Similarly, it is asked, how do you punch a hole in cardboard?

Punching Through Stacks of Paper To create holes in a stack of paper or cardboard at least 1/8-inch thick, a drill and drill bit handle the task with ease. Stack the paper or cardboard atop another sheet of corrugated cardboard or a piece of scrap wood.

Also, how do you poke holes in leather? No need for a hammer, heated nail held firmly with pliers, can make the hole you want. Careful usage of a sharp pointed knife can easily cut you another hole in your leather belt. Mark out where you want the new hole, and put the knife at the marker and rotate gently. Soon you'll have your extra hole.

Also question is, how do you empty a hole puncher?

How to Empty the Hole Punch Waste Container

  1. Make sure that the machine is not operating, lift the top transport cover, and then open the front transport cover of the finisher (Figure 1).
  2. Pull out the hole punch waste container (Figure 2).
  3. Empty the container (Figure 3).
  4. Insert the emptied hole punch waste container into the finisher until it stops (Figure 4).

How do you punch a hole in the middle of a paper?

Creating the Illusion of Punching the Center of a Page

  1. Choose your background paper.
  2. Slide the small square of paper into your punch.
  3. Place the punch and paper on the table.
  4. Cut another square from your choice of coordinating paper.
  5. Glue the coordinating paper to the piece with the punched shape.

28 Related Question Answers Found

How do you cut cardboard cleanly?

How do you make a perfect circle with cardboard?

How do you hit 4 holes on a4 paper?


What should a 3 hole punch be set at?